Table of Contents
Advertisement
Preparing the Remote Control
The functions of the camera recorder can be configured using a wired remote
control.
1
Connect a wired remote control to the camera recorder.
Connect the wired remote control (sold separately) to the "REMOTE"
jack of this camera recorder.
TT.1
BATT.2
REMOTE
AV
DC
.
2
Turn on the power of the camera recorder.
Caution :
Turn off the power of the camera recorder when connecting a wired remote
0
control.
Attaching the Headphones
You can attach optional headphones to this unit.
1
Connect the headphones to the headphones connector.
TT.1
BATT.2
REMOTE
AV
DC
.
Memo :
The volume level of the headphones can be adjusted using the "ADJ." dial.
0
The built-in speaker is usable only in the Media mode. Audio is not output
0
from the built-in speaker during Camera mode.
Audio level in the Camera mode and Media mode can be adjusted
0
separately.
When in the Media mode, the volume of the headphone and speaker are
0
adjusted at the same time.
The built-in speaker cannot be used when the headphone jack is
0
connected.
Connect the wired remote
control
Attaching the External Microphone
You can attach a microphone (optional) to the microphone holder.
Knob
"MIC" Jack
.
1
Turn the knob on the microphone holder anticlockwise to loosen it and
open the microphone holder.
2
Place the microphone in the microphone holder.
3
Turn the knob on the microphone holder clockwise to secure the
microphone.
4
Connect the cable of the microphone to the "MIC" jack.
Memo :
Phantom microphones are not supported. Use a microphone that supports
0
plug-in power.
Tripod Mounting
This unit can be mounted on a tripod (or monopod). This is useful for
preventing camera shake and recording from the same position.
.
To prevent this unit from falling off, check the tripod mounting screw holes
0
and positioning holes on the unit carefully before mounting, and turn the
screws until they are fastened firmly.
Caution :
To prevent injuries or damages which may result if this unit falls off, read
0
the instruction manual of the tripod (or monopod) to be used and make
sure that it is securely attached.
Memo :
It is recommended to use a tripod or monopod when recording in
0
conditions prone to camera shake (such as in dark places or when zoomed
to the telephoto end).
Set the image stabilizer to "OFF" when using a tripod for shooting.
0
"Reducing Camera Shake" (A p. 37)
Getting Started
Microphone
Microphone Holder
15
Advertisement
Table of Contents
