Glow-Powered Radio Tray And Fuel Tank Installation - Hangar 9 P-40B Warhawk 50 ARF Assembly Manual

Glow-Powered Radio Tray and
Fuel Tank Installation
Required Parts
Fuselage assembly Radio tray, glow powered
Hook and loop strap M3 washer
Fuel tank
M3 x 8 socket head wood screw (2)
M3 x 12 socket head cap screw

1. Locate the items for this section of the manual.

2. Prepare the rudder and elevator servos by installing
the brass eyelets and rubber grommets.

3. Place the throttle servo in the opening inside the
fuselage with the output shaft to the side as shown. The
servo will be centered in the opening to prevent vibrations
from the airframe from being transferred to the servo. Use a
pencil to mark the location for the screws that will secure the
servo to the servo tray.
Hangar 9 P-40B Warhawk 50 ARF

4. Use a pin vise and 1/16-inch (1.5mm) drill bit to
drill the holes for the four mounting screws.

5. Use a #1 Phillips screwdriver to run a servo
mounting screw in each of the four holes. Make sure to
remove the screw before proceeding to the next step.

6. Apply 1–2 drops of thin CA in each hole drilled. This
will harden the surrounding wood, making the screws more
secure when installed.

7. Use the screws provided with the servo and a #1
Phillips screwdriver to secure the servo to the servo tray.
Secure the receiver and receiver battery to the radio tray using
hook and loop tape (not included) and a hook and loop strap.
Repeat steps 2 through 6 for all the servos.
35