Error Display - Nikon One-Touch Zoom 90s One-Touch Zoom 90s AF Quartz Date Repair Manual

(22) Error display

(22) Error display
１ Lens barrel NG
２ Shutter NG
３ FFS NG
４ 1 frame advance NG
５ Rewinding NG
How to release
ｎ 2 When the lens barrel is in the middle of WIDE and TELE,
press lightly the release button, press the zoom button,
main switch button and MU button and open and then close
the camera back.
When the lens barrel is in the push-in position, press the
main switch button, open and then close the camera back
and press the MU button.
condition is set.
If the same error is displayed though the above procedure is
performed, disassemble and repair the camera.
Load the battery again, open and then close the camera
ｎ 3
back, press the MU button and press lightly the release button.
ｎ 1
Consequently the initial condition is set.
If the same error is displayed though the above procedure is
performed, disassemble and repair the camera.
If FFS fails, the operation stops just under the condition and
"E" blinks.
The error condition is released by opening the camera back.
If 1 frame advance fails, automatic rewinding starts and, when
rewinding is ended, "0" blinks.
The error condition is released by opening the camera back.
If an accident is caused during rewinding and so emergency stop
occurs, the counter blinks at that time to show that the camera
is in an abnormal condition.
Open the camera back in a dark box, take out the film and close
the camera back.
- M5 • One Touch Zoom 90s AF -
Consequently the initial condition is set.
Consequently the initial
FCA54001-R.3567.A