Scanning options
Scanning temperatures
Subject to the connected components and settings you have made, you can scan the
current temperatures and operating conditions.
Press the following keys:
1. "MENU".
2. |/~ for "Information".
Please select
Heating circ. 1
Heating circ. 2
i Information
Boiler information
Select with |/~.
i Boiler
Burner status:
Idle state
Continue
■ "Burner status"
– "Idle state"
– "Heat up"
– "Control mode"
– "Burnout phase"
– "Cleaning during operation" – for
automatic cleaning of the heat
exchanger surfaces in the boiler
– "Cleaning when stopped" – for
automatic cleaning of the ash grate
■ "Outside temperature"
■ "Boiler water temperature"
Resetting to "0" see page 47.
*1
*2
The fuel consumption is a calculated value. It can vary from the actual value by up
to 15%.
44
3. d
4. |/~ for the following selection:
HK1
HC2
5. d
■ "Upper buffer temperature" – if the
heating water buffer cylinder is
available
■ "Lower buffer temperature" – if the
heating water buffer cylinder is
available
■ "Burner operation"
burner
■ "Burner cycles"
■ "Fuel consumption"
relevant setting has been made by the
heating contractor
■ "Delivery times" "Enable"/"Disabled"
to confirm.
■ "Boiler"
■ "Common circuit"
■ "Heating circ. 1"
■ "Heating circ. 2"
■ "DHW"
■ "Solar"
to confirm.
*1
– Hours run -
*1
*1*2
– , if the