Setting The Reduced Room Temperature; Switching Times - Viessmann VITOLIGNO 300-P Operating Instructions Manual

Setting a permanent room temperature

Setting the reduced room temperature

Press the following keys:
1. "MENU".
2. |/~ for selecting "Heating circuit
1" (HK1), "Heating circuit
2" (HK2) or "Common
circuit".
3. d to confirm.
4. |/~ for "Reduced room temp.".
5. d to confirm.
Reduced room temp.
Frost protection
Change

Switching times

■ For central heating, up to four changes per day between standard and reduced
room temperature can be programmed (four time phases).
■ At the factory, time phase ! is set for every day from 06:00 to 22:00 h, i.e. during
that time, all rooms are heated to the standard room temperature.
■ You can set switching times individually for the following days or parts of the week:
– The same for every day: Monday to Sunday
– For individual parts of the week: Monday to Friday and Saturday to Sunday
– For every day individually: Monday, Tuesday, etc.
When setting switching times, bear in mind that your heating system requires some
time to heat the rooms to the required temperature.
For the steps for setting switching times, see page 20.
For a sequence of steps to delete a time phase, see page 21.
Adjusting the room temperature
(cont.)
6. |/~ for the required temperature.
Note
When setting the reduced
room temperature to 3 °C,
"Frost protection" will be
displayed.
7. d to confirm.
In the display "Accepted"
appears briefly.
8. g press until the standard
display is shown (see
page 10).
HK1
3°C
19