Scanning Information And Resetting Values - Viessmann Vitocrossal 100 Operating Instructions Manual

Scanning information and resetting values

Subject to the components connected and the settings
made, you can scan current temperatures and operat-
ing conditions.
Press the following keys:
1. for settings; " " flashes.
2. for " ".
3. OK to confirm.
4. / for the required information.
5. OK to confirm; if you want to reset the value to "0"
(see following table), " " flashes.
Information appears in the following sequence:
Shown on display
0 10
1 15
2 95
3 65
4 45
5 50
51 50
52 50
5c 95
5 45
□
53 50
54 50
6 70
2 6 3 5 7 2
1
0 3 0 5 2 9
3
0 0 1 4 1 7
5
Meaning
LON subscriber number
°C Outside temperature
°C Flue gas temperature
°C Boiler water temperature
°C Temperature of heating water buf-
fer cylinder or low loss header
°C DHW temperature
°C DHW temperature, top
°C DHW temperature, bottom
°C Collector temperature
°C DHW temperature with solar oper-
ation
°C Temperature sensor
°C Temperature sensor
°C Collector temperature
h Burner hours run
Burner starts
h Hours run, solar circuit pump
6. OK to confirm; the value is reset.
Example:
On the display, you can see "3" which shows the boiler
water temperature. The current boiler water tempera-
ture is 65 °C.
¸
3
Fig. 4
Note
The scan mode terminates automatically after
30 minutes or if you press
Notes
–
Displayed only if an outside temperature
sensor is connected.
–
–
Displayed only if a heating water buffer cyl-
inder or low loss header is connected.
Displayed only if a DHW cylinder is connec-
ted.
Displayed only if two cylinder temperature
sensors are connected.
Displayed only if a Viessmann solar control
module is installed.
Displayed only if a solar thermal system is
connected.
Displayed only if the Viessmann solar con-
/
trol module is available and a third tempera-
ture sensor is connected.
Displayed only if the Viessmann solar con-
aÖ
trol module is available and a fourth temper-
ature sensor is connected.
Displayed only if a solar thermal system is
connected.
Number of hours run.
The hours run can be reset to "0" with "
The number of burner starts can be reset to
"0" with "
D
Displayed only if a Viessmann solar control
module is installed.
The hours run can be reset to "0" with "
Calling up information
°C
6 5
.
".
".
D
".
D
15