Hitachi VK-S274R Service Manual page 30

Adjustment > Preparations for Adjustment
7) The ZMAP will start: Make sure that the model select
screen appears on the PC display. (See the model select
screen)
If the model select screen does not appear, make sure of
the following:
a) Power is supplied to the video camera and DSP-R jig.
b) The designation of drive (in step 5) is correct.
c) The designation of serial port is correct.
d) The correct adjustment floppy disk has been correctly
inserted.
8) If the appropriate model is displayed on the model select
screen, input the number to PC. If the appropriate model
name is not shown on the model select screen, input P to
PC until the model name appears. If an erroneous model
name or number is selected, misoperation message will
appear on PC display: Press any key to restore the model
select screen.
9) The screen for verifying the model name will appear on
PC display: If it is correct, input Y to PC. If it is incorrect,
input N and start over (from step 8).
10) Make sure that the main menu appears on PC display: If
it does not appear, check whether model selection (in step
8) is correct.
To terminate the adjustment program (ZMAP):
Press the Esc key once to three times until the PC display
returns from each menu screen to the MS-DOS screen. When
the MS-DOS screen appears on PC display, turn off the video
camera and jig.
(Continued from preceding page)
Model select screen
***********************************************************
***********************************************************
Model select (Input
the number).
Screen for verifying model name
Input Y.
Main menu
***********************************************************
***********************************************************
Reference
Misoperation message
6 - 4
MODEL SELECT
[1] ××××××××
[2] ××××××××
[3] ××××××××
[4] ××××××××
[5] ××××××××
[P] NEXT SELECTION
[ESC] END
Please select the type of the set
Press [1] - [5] or [P] or [ESC]
Selected model is ××××××××
Are you sure ? (Y/N)
MANUAL ADJUSTMENT PROGRAM
[A] DATA INITIALIZE
[B] ELECTRIC VOLUME
[C] ADJUSTMENT
[D] AUTO FOCUS
[E] SPOT NOISE
[ESC] END
Please select [A] - [E] or [ESC]
CAN NOT FIND THE DATA FILE
**** PRESS ANY KEY ****