Alcatel Speed Touch Home User Manual page 55

IP Address Table
3EC 17058 AAAA TCZZA Ed. 03
The 'Routing' web page contains the following tables:
The 'IP Address table' summarizes all IP addresses configured on
any of the Speed touch Home interfaces.
The 'IP Address table' contains the following columns (See figure
30):
Intf
"
Indicates the interface (Intf) to which the IP parameter set was
assigned to.
It can take several values depending on the packet services that
are active. The Ethernet (eth0) and the Loopback (loop) are
always present.
Address
"
Shows the IP address of the interface.
Netmask
"
Shows the Netmask of the interface.
Type
"
Indicates the origin of the IP parameters and can take following
values:
Auto: The parameters were acquired automatically through
D
DHCP (for more information see the 'DHCP' web page), or
are typical standard IP addresses (loop).
User: An additional IP parameter set was added through the
D
'Initial Setup' web page.
Extra: An additional IP parameter set was added through the
D
bottom row of the 'IP Address table'. The default IP address
10.0.0.138 is also of this type.
Temp: This (additional) IP parameter set was added via a
D
Ping of Life .
Transl
"
Has no meaning for the STHome and will always show 'None'.
To add an IP address, specify the IP address and Netmask in the
bottom row of the 'IP Address table', and click
7 Speed Touch Home Local Configuration
.
55 / 86