Alcatel Speed Touch Home User Manual page 41

3EC 17058 AAAA TCZZA Ed. 03
The procedure for Microsoft Windows platforms is described below.
Small differences may occur for other platforms.
1. Turn off the Speed Touch Home.
2. Open a DOS window.
3. In this DOS window, execute the command:
arp –a
This command allows you to overview the current entries in the
ARP cache.
4. Now add a static entry to the PC's ARP cache, according to the
syntax below:
arp –s <STHome IP address> 01–90–D0–80–01–01
<STHome IP address> is a placeholder for the IP address to
be assigned to the Speed Touch Home.
In the subsequent example, 10.0.0.145 will be used.
The MAC address 01–90–D0–80–01–01 is a special MAC
Group address from Alcatel on which the STHome will react.
In the example the command would be:
arp –s 10.0.0.145 01–90–D0–80–01–01
5. Verify if this step was successful by executing
arp –a
In the entries list, the arp –s entry should be added.
6. Turn on the STHome and wait for 30 seconds to allow the POST
to end.
7. Ping the IP address you just entered in the ARP cache within 60
seconds:
ping <STHome IP address>
For this example the command is:
ping 10.0.0.145
8. If successful, the Speed Touch Home has configured this
IP address and will reply to the ping.
9. You may clear the entry in the ARP cache by issuing the following
command:
arp –d <STHome IP address>
Leaving the entry in the ARP cache does not harm the general
operation.
6 Lost Speed Touch Home
41 / 86