Front Wheel Maintenance; Fitting Your Golf Bag; Operating The Top Box; On/Off Speed Control Button - MGI Hunter Quad User Manual

6.3 Front Wheel Maintenance

During the life of the MGI Quad buggy, you may experience
wearing of the front wheel gasket. This may result in a noise
coming from the front wheel during use. You can replace this
gasket at home using 1 of the 4 gaskets included in the spare
parts included with your buggy. Follow these easy steps
Step 1: Remove the front wheel following the steps above.
Step 2: Place the rubber gasket over the wheel pin.

7.0 Fitting Your Golf Bag

Securing the top bag strap
• Provide a good position for the positioning of both ends of
the elasticised straps
• Stretch the longer end of the strap and secure to the
extended shorter end
• The attached strap should now be connected
Adjusting the length of the top strap
• The plastic bar on the longer length can be adjusted to
ensure the bag is secured properly in place.
Securing the lower bag strap
• The MGI Quad buggy is designed so the lower bag strap
is no longer required. However the lower strap has been
included for your own preference. It is easily attached by
clipping each end of the strap into the eyelets on the lower
bag support.
14
8.0 Operating the Digital Top Box
4. 5.
6.
1. 2.
3.

8.1 On/Off Speed Control Button

To start your buggy:
1. Preset your desired speed by rotating the speed control
button clockwise to increase speed, or anticlockwise to
decrease the speed. The speed setting chosen is displayed
on the colour screen on the left side. Then tap the speed
control button to start and stop the buggy, or
2. Simply tap the speed control button to start the buggy,
then adjust the speed settings to your desired speed.

8.2 Battery Level Indicator

Battery indication is located on the right side of the top screen.
Four coloured bars are highlighted showing full charge. The
lesser number of bars displayed, means there is less battery life
available. You should always check the battery status before
you play golf to ensure the four bars are there.
The battery indicator is set to measure the capacity of your
battery. The battery type is displayed with an L [lithium] or and S
[SLA] under the battery level indicator. If you need to change the
battery type:
1. Disconnect the battery
2. Hold down the button to the Control button 2 [right of the
Speed Control]
3. Keep holding the button down, and connect the battery
4. Release the button, then press it again to shift between L
for Lithium and S for SLA battery type.
5. Once the battery type is set disconnect the battery.
MGI Hunter™ Quad User Manual
1. Control button 1
2. Control button 2
3. Speed Control ON / OFF button
4. Speed indicator
5. Battery level indicator
6. S-SLA battery type / L – Lithium
15