Unpacking; Fitting The Instrument; Surface Mounting - Raymarine ST60 Owner's Handbook Manual

Chapter 3: Installation

Unpacking

Fitting the instrument

CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard by
weakening critical parts of the vessel's structure.
Unpack your ST60 instrument and check that the items described in
Introduction are present.
Each ST60 instrument is supplied with a standard bezel for surface
mounting. Optional mounting kits are available for flush mounting and
bracket mounting the instrument. If you have ordered the flush
mounting option, a low-profile bezel and four fixing screws are also
provided.
The ST60 Steering Compass instrument can be installed using one of a
number of different mounting options:
• Surface Mounting. Gives a profile of approximately 24 mm.
• Flush Mounting. Gives a profile of approximately 6 mm.
• Bracket Mounting.
The ST60 Steering Compass instrument can also be mounted behind a
panel with just the instrument dial and keys visible.

Surface mounting

To surface mount your ST60 instrument (see the Surface mounting
illustration):
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate
the rear of the instrument and connectors.
2. Apply the surface mount template (supplied at the rear of this
handbook) to the selected location and mark the centres for the
fixing studs (1) and the aperture (3) that will take the rear casing of
the instrument.
15