10
Connections to other equipment
If your Raymarine equipment is to be connected to other equipment using a cable
not supplied by Raymarine, a suppression ferrite MUST always be attached to the
cable near the Raymarine unit.
2.2 Installation procedure
As it is not practical to describe procedures for all possible installation scenarios,
the procedures given here describe the broad requirements for installing a Wind
Vane and ST60+ Club House Wind instrument. Adapt these procedures as
appropriate, to suit your individual requirement.
CAUTION: Maintain structural safety
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard
by weakening critical parts of any structure.
Unpacking
Unpack your ST60+ instrument and check that the items described in the
are present.
Each ST60+ instrument is supplied with a standard bezel for surface mounting.
Optional mounting kits are available for flush mounting and bracket mounting
the instrument. If you have ordered the flush mounting option a low-profile bezel
and four fixing screws are also provided.
Fitting the instruments
The ST60+ Club House Wind instrument can be installed using one of a number of
different mounting options:
• Surface mounting. Gives a profile of approximately 0.95 in (24 mm).
• Flush mounting. Gives a profile of approximately 0.25 in (6 mm).
• Bracket mounting.
ST60+ Club House Wind Instrument Owner's Handbook
D3548-6
Preface