Bracket Mounting; Fitting Transducer; Installation - Raymarine ST60 Owner's Handbook Manual

Chapter 3: Installation

Fitting transducer

3. Apply the template flush mount (supplied at the rear of this
handbook) to the selected location and mark out the aperture into
which the assembled instrument and bezel will sit.
4. Cut out the aperture (3) for the assembled instrument and bezel
and remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the bezel.
6. Screw the two fixing studs (1) into the threaded sockets on the rear
of the instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the
panel.
8. Locate the flush mount bracket (6) onto the fixing studs and
secure the assembly to the panel with the thumb-nuts (5).

Bracket mounting

A Control Unit Mounting Bracket (Part No. E25009) enables you to
mount your ST60 instrument in locations where other forms of
mounting are impractical. Although this provides a useful alternative
method for securing your instrument, it is only suitable for use in
positions where the instrument will not be exposed to water.
To bracket mount your ST60 instrument, do so in accordance with the
Control Unit Mounting Bracket Instruction Sheet.
If you are fitting an ST60 Steering Compass instrument and wish to
use it as a stand alone instrument, you need to fit a Fluxgate Compass
transducer.
Note: If the ST60 Steering Compass is to form part of a system which
includes a SeaTalk autopilot, the ST60 Steering Compass instrument
does not need its associated Fluxgate Compass transducer to operate
as a slave to the autopilot. However, if the Fluxgate Compass
transducer is fitted, the instrument will operate as a master.

Installation

Determine a suitable position for the Fluxgate Compass transducer, as
described under Site requirements.
19