Installation; Suitable Mounting Locations; Mounting The Rack Tray - Black Box KVTA170UK-16 User Manual

ServView CX Rack Tray

3. Installation

3.1 Suitable mounting locations

• It is very important to locate the ServView CX Rack tray in a suitable environment.
• The surface for placing and fixing the rack tray should be stable and level, or mounted into a suitable cabinet.
• Make sure the place has good ventilation, is out of direct sunlight, away from sources of excessive dust, dirt, heat, water, mois-
ture and vibration.
• Position the rack tray with respect to related facilities.

3.2 Mounting the rack tray

1 Determine the appropriate position for the rack tray within your rack frame. Insert two of the supplied cage nuts in each of the
rear vertical rack rails and one cage nut in the lower position of each front rack rail. See Figure 3-1.
2 Attach the supplied left and right mounting brackets to the positions in your rack frame where the cage nuts are located and
adjust the bracket depths to suit the depth of the rack.
For each mounting bracket:
• Use two M6 screws and cup washers to fix the bracket to the rear rack rail.
• Use one M6 screw and cup washer (only in the lower hole of the bracket) to fix the bracket to the front rack rail.
Leave all screws loose until the rack tray assembly has been put into place.
Page 10
Figure 3-1. The mounting brackets.
724-746-5500 | blackbox.com
The unit is heavy.
Therefore when
installing, place
the rack tray on
a sturdy, level
surface to prevent
it from accidentally
falling and causing
damage to other
equipment or
injury to persons
nearby.