Pioneer AVIC-N2 Service Manual page 294

1
5. When the angle voltage reaches the voltage for 110°, brake is applied to the angle driving motor, and the
ejection is completed. (In case the previous angle is stored in the memory, the motion continues to that angle.)
A
B
6. When the setback is set to ON, after the monitor angle voltage has reached the previously memorized voltage,
brake is applied to the angle driving motor, then the forward/backward driving motor is rotated in slow speed
in the storage direction. After that, when LIFTSW has switched from L to H, the forward/backward driving
motor is stopped.
C
D
- Explanation of the FLAP storage motion
1. When CLOSE key is pressed, or after 6 seconds from ACC OFF when auto OPEN/CLOSE is being set to ON, the
angle driving motor is rotated in the 0° direction. In case the setback setting is ON, the forward/backward
driving motor is rotated in high speed in the ejection direction and the motor continues to rotate for 600ms
from the time when LIFTSW is switched from H to L, then the angle driving motor is rotated in the 0° direction.
E
F
294
1
2
110° voltage position or the last memory position.
AVIC-N2/XU/UC
2
3
3
4
4