Pioneer AVIC-N2 Service Manual page 232

1
A = A coordinate which is already stored in the SRAM (If there is no previous data in the SRAM, "min=90,
max=180" will be displayed).
A
B = An updated coordinate which is planned to be set in the SRAM this time (If there is no previous data in the
SRAM, "min=90, max=180" will be displayed).
[BACK] : The preset effective range is registered, and the screen will return to the remote controller inspection
menu. The data of the effective range will be recorded in the SRAM.
In case the compensation value is not preset in the SRAM, the following initial (default) value will be entered
automatically at the time of navigation system boot up.
min_x = 42 (right edge limit value)
max_x = 246 (left edge limit value)
min_y = 49 (bottom edge limit value)
max_y = 238 (top edge limit value)
B
2. Setup calibration
C
Explanation
• A [+] cursor is displayed at 16 locations on the screen for calibration. Finally, verification of a single point is made.
The cursor is always displayed at one location only, and moves on to the next location as the current one is
correctly pressed.
• When pressing on the [+] cursor, make sure to press at the center of "+".
• The result of calibration will be recorded in the SRAM.
• If effective operation is not made for 30 seconds, the system will recognize as "erroneous end" and stops the
D
calibration.
E
F
232
1
2
AVIC-N2/XU/UC
2
3
3
4
4