Pioneer AVIC-N2 Service Manual page 257

5
12. Language selection flag initialize
12. Language selection flag initialize
• When the system enters into this inspection, language selection will be set to the original setting made at
the time of shipment (i.e. no setting).
* The setting is made to display the screen for selecting the language to be used at the initial boot up after
the shipment out of the factory.
• The setting is made when the system enters into this inspection.
• You can move on to the next inspection by the [ ] key on the remote controller.
13. All memory clear (Not for service)
• SRAM (application domain) is cleared.
• FLASH (application domain) is cleared.
• Sensor learning level is cleared.
• If SRAM clear is not successful, FLASH will not be cleared.
• After the inspection screen is displayed, the above process is executed by the [NAVI] key on the remote
controller.
• The result of the process is displayed.
• Only when everything is OK, you can move on to the next inspection by the [ ] key on the remote
controller.
5
6
Language selection flag is initialize.
[joy stick down] It progresses to the next inspection.
13. All memory clear
The clearance of SRAM (application domain)
The clearance of FLASH (application domain)
Elimination of a sensor study value
[NAVI] Inspection is performed.
AVIC-N2/XU/UC
6
7
7
8
A
B
C
D
E
F
257
8