Repair; Lifting The Vehicle - Cushman Titan XD Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

REPAIR

View from Underside of Vehicle
Some servicing operations may require the front wheels,
the rear wheels, or the entire vehicle to be raised.
Front
Frame Rail
To reduce the possibility of severe injury or
death from a vehicle falling from a jack:
Be sure the vehicle is on a firm and level sur-
face.
5
Never get under a vehicle while it is supported
by a jack.
Use jack stands and test the stability of the vehi-
cle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is extremely
unstable during the lifting process.
When lifting the vehicle, position the jacks and jack stands
at the areas indicated only.

Lifting The Vehicle

Tool List Qty.Tool ListQty.
Floor Jack ....................................................................1
Jack Stands .................................................................4
Wheel Chocks..............................................................4
Remove payload from vehicle before lifting. No person(s)
should be in or on the vehicle while lifting.
To raise the entire vehicle, install chocks in front and
behind each front wheel. Center the jack under the rear
frame crossmember. Raise the vehicle enough to place a
jack stand under the outer ends of the rear frame cross-
member.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack at the flat section of the steering box skid plate. Raise the vehicle enough to place jack stands under
the frame members as indicated.
Lower the jack and test the stability of the vehicle on all four jack stands.
If only the front or rear of the vehicle is to be raised, place the chocks in front and behind each wheel not being raised
to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
5 - 4