Performance; Speed Control; Pedal-Up Braking; Walk-Away Feature - Cushman Titan XD Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

PERFORMANCE

Vehicles operate only when the Run - Tow/Maintenance/Storage switch is in the RUN position.
The vehicle's top speed is sensed and regulated directly by the controller and the feature to slow the vehicle when
the accelerator pedal is up is mild.

Speed Control

To prevent the possibility of loss of control that could cause severe injury or death, use service
brake to control speed. The Speed control system is not a substitute for the service brake.
Speed control system vehicles are equipped with a regenerative motor control system.
Example: If all of the following events occur...
a) the vehicle is being driven down a slope
b) the vehicle attempts to exceed the specified top speed with the accelerator pedal depressed or released
the regenerative braking will limit the speed of the vehicle to the specified top speed (the warning beeper will not
sound). When the regenerative braking system is activated by this sequence of events, the motor generates power
which is returned to the batteries.

Pedal-Up Braking

Pedal-up braking is regenerative braking that occurs when the accelerator pedal is released while the vehicle is
moving.
Example: If all of the following events occur...
a) the vehicle is being driven down a slope
b) the accelerator pedal is released for more than one second
the pedal-up braking will slow the vehicle (the warning beeper will not sound) until it rolls to a stop, or the accelerator
pedal is applied. When pedal-up braking system is activated by this sequence of events, the motor generates power
which is returned to the batteries.

Walk-Away Feature

Walk-Away limits vehicle movement without driver input, slowing the vehicle to 2 mph (3 kph) and sounding an audi-
ble alarm (reverse beeper).
Example: If all of the following events occur...
a) the vehicle has been stopped for more than 1.5 seconds
b) the accelerator pedal has been released for more than one second
c) the vehicle begins to roll above 2 mph (3 kph)
the Walk-Away feature will limit speed to approximately 2 mph (3 kph) and the warning beeper will sound. When the
accelerator pedal is depressed, the Walk-Away feature and warning beeper will be overridden and normal vehicle
operation resumes. The system functions in all key switch positions.

Anti-Roll Back Feature

Anti-Roll Back, like Walk-Away, limits backward motion of the vehicle down an incline to less than 2 mph (3 kph). See
Walk-Away Feature above.
OPERATING PROCEDURES
4
4 - 5