Installation; Telephonelineand Acconnections - Sanyo SFX-32 Service Manual

1. INSTALLATION
(1) Unpacking
w
To unpack the SFX-32:
1. Open Ihe carton.
2. Remove theaccessories (handset, recording paper roll, etc.) from the carton.
3 Remove the faxmachine along with the foam braceson both sides.
4. Remove the polyethylene wrapping around the fax machine.
5. Remove the transportation tapes.
6. Save the carton and the foam braces for later storage and/or shipping.
7. Place the machine where there is access to an AC outlet and a modular phone jack. (Be sure to observe the
precautions below.)
Placement precautlona
Avoid placing the SFX-32 in humid or dusty places, or in places where it will be exposed to excessive heat
(direct sunlight, heaters, etc.).
Do not step on or set anything on the AC cord. DAMAGE TO THE AC CORD IS A SAFETY RISK AND CAN
cm3E
A FIRE.
Install the unit only on a stable surface.
Do not connect the SFX-32 to the same AC outlet as appliances that generate large amounts of interference
(heaters with thermostats, appliances with motors, etc.). It is best to use a completely separate electrical outlet.
Q Keep the SFX-32 away from water. If water accidental y enters the unit, unplug the AC power cord immediately.
DO NOT SWITCH THE UNIT ON AGAIN. Contact an authorized Sanyo service center or dealer.
L
Handling precaution
Do not remove any parts that are held in place with screws. (The SFX-32 does not contain any user-serviceable
items).
. Maintain standard room temperature 5°C – 35°C (410F – 95"F) during use. Do not subject the unit to shock or
vibration. Do not move the unit while it is in use.
. A rapid increase in room temperature in cool weather can cause condensation to form inside the unit. If this
happens, wait at least 15 minutes after turning the unit on before attempting to operate it.
Failure to do so may result in paper jams and/or poor print quality.
When cleaning the cover or operation panel of the unit, wipe gently using a damp cloth to which a small amount
of a neutral detergent has been added. NEVER USE SOLVENTS OR CHEMICALLY TREATED CLOTHS.
(2) Telephone line and AC connections
I Connecting to AC
1
[ Connecting to telephone line
The
S%-32
shouldnot share a modularlack with orharcommumcation
eqwpment, s this mayobstruct t he properfunctioning o f the umt.
—l—