Sanyo SFX-32 Service Manual page 28

4) Press ~ or m]
~ :Initialize RAM CODE and goes to next menu,
ml: Next menu (One touch and speed dial)
6)
7)
~ :Clear one touch and speed dial memory and
goes to next menu.
m]: Next menu (Report Data)
Press ~ or m]
~ :Clear activity report data and return to stand-by
display
m]: Return to stand-by display
In case of S-RAM error
Alarm sounds continuously and the machine 'goes into
"dead lock" condition. + Repairing is required.
b)
RAM CODE SEl_HNG
1) Press ~ + -] (over 1sec.)
(Refer to Page 25.)
2)
3)
4)
5)
6)
7)
Press m]
~ :Change the contents.
-]: Issue RAM CODE UST and return to STAND-
BY.
Input the SW. No. using numeric or -~ key and
press ~.
Input the SET CODE using numeric or m]
press ~.
(Next SW. No. is automatically displayed.)
Repeat the steps (4) and (5) on demands.
Press -1 to finish.
The SFX-32~returns to STAND-BY.
c) SCAN TEST
1) Press ~ + ml .(over 1sec.)
(Refer to Page 25)
2) Press -1 twice.
3) Press ~.
key and
O.T & S.D CLEAR?
IREPORT DATA CLR?I
20 Oct. '93 12:00
SRAM CHECK ERROR
-.
INITIAL SET ?
RAM CODE SET ?
I
Sw.
CODE
I
Sw. 01 CODE
SW
01
CODE 03
liNi TIAL sET 7 I
SCAN TEST ?
I N
I** SCAN TEST * I
4) Press w] to complete.
A shading signal waveform is memorized then, return to
STAND-BY.
—26—