Sanyo SFX-32 Service Manual page 26

d) Remove the CIS assembly. (See figure 6-11)
* CIS should be replaced with CIS assembly.
~
(XSayernbly C1.Scon~ector
El
—
Lo o
oyl-Joo —Q-@%&5&&52-Jr
CIS attachment spring
4
take out direction of CIS
FIGURE 6- 11
(2) Replacement of the Thermal Head
a)
b)
c)
d)
Gather the original guide to the center and remove
two screws securing the receiving cover.
Press the Open button and remove two screws '
securing the cover located under the thermal head.
(See figure 6-12)
Disconnect the connector of the thermal head.
Remove two screws securing the thermal head.
IFf==ie=a=i!z==i
two
screws
securing the thermal
haad .
FIGURE 6-12
bracket
bracket
~ press this direction
$ FIGURE
6-13
When attaching the thermal head to the bracket
head, the thermal head should be pressed the
arrow direction. (See figure 6-1 3)
(3) Replacement of the Auto Cutter
a) Remove the receiving mechanical unit. (Refer to
the 6-1 -(3))
b) Remove one screw securing the cutter unit (See
figure 6-14)
receiving mechanical unit
:::.wc=?-
one
screw securing the cutter unit
the guide cutter 1, 2
I
guide cutter 3
I /
two screws securing the guide cutter 3
connector of the guide cutter
d
FIGURE 6-15
(4) Replacement of the ADF (Automatic Document
Feeder) unit.
a) Open the operation panel.
b) Remove two screws securing the ADF unit. (See
figure 6-16)
two screws securing
the ADF unit
~ ADF unit
FIGURE 6-16
c) Replace new ADF unit and check the performance.
c)
d)
(k
FIGURE 6-14
Disconnect the connector of the cutter unit
Remove two screws securing the black guide
cutter (three pieces) from the cutter unit. (See figure
6-15)
Please note that two wire fixers are fixed together
with screws.
When re-assembling, put them to the same
r)osition.
'24-