Sensor (Tray 2 Feed-Out) Removal - Lexmark W840 Service Manual

4024-XXX

Sensor (tray 2 feed-out) removal

1.
Remove the MPF rear cover. See
2.
Remove the MPF feed unit assembly. See
3.
Remove the printer left door assembly. See
4.
Open the printer left lower door assembly. See
page 4-68.
5.
Remove the two screws securing the tray 2 feed-out sensor guide (A).
6.
Remove the tray 2 feed-out sensor guide (A) while pulling on its center most point.
7.
Disconnect the connector from the sensor (tray 2 feed-out) (B).
8.
Release the hook securing the sensor (tray 2 feed-out) (B).
9.
Remove the sensor (tray 2 feed-out) (B).
4-82
Printer Service Manual
"MPF rear cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door support strap removal" on page
"Printer left lower door assembly removal" on
A
B
Hook
4-56.
4-52.
4-72.
Left
A