Dc Sensitive/Pure Dc Rcd Test; Type A (Dc Sensitive) Rcd Test; Type B (Pure Dc) Rcd Test - Megger MFT1700 series User Manual

.3 Press the TEST button
The RCD should trip and the display show the trip current in mA.
If the RCD fails to trip, >***mA is displayed, where *** = 110% of the nominal RCD trip currnet.
8.7

Type A (DC Sensitive) RCD test

'Type A' RCDs are sensitive to pulsed DC as well as AC fault currents, and are tested with a pulsed waveform. The RMS
current is √2 x the rated operating current of the RCD. As with the normal RCDs, these should be tested with 0° and 180°
polarity.
.1 To select a Type A RCD see section 8.2
These are tested in exactly the same manner as those tested in section 8.3 to 8.6.
Note: Type A RCDs should be tested at 0° and 180° on 1/2xI, 1xI and 5xI
8.8

Type B (Pure DC) RCD test

'Type B' RCDs are sensitive to pure DC fault currents, as well as pulsed AC and ordinary AC fault currents. First they are tested as Type A
then type B, using a pure DC test current..
Type 'B' RCD's are only tested on the 1xI range. The result displayed in milli-amps (mA).
.1 Test the RCD in 'type A' mode for 1/2xI , 1xI and 5xI if it is a 30 mA RCD. Test it in 1xI only if it is > 30 mA.
.2 To select a Type B RCD press and hold the mode button <-> repeatedly until the
.3 Connect the Red L1, Green L2 and Blue L3 terminals of the MFT to the RCD Live, Neutral and Earth as below ('type
AC' and 'type A' RCD's only need Phase and Earth connections).
.4 Select the 1xI range on the left range knob, and the current rating of the RCD on the right range knob.
.5 Press the TEST button.
.6 The RCD should trip and display the trip current in mA. The "Touch Voltage" is displayed on the small digital
readout.
Notes: Only 1 x I is available. Selecting other test currents will reset the test type to AC.
Only 10 mA, 30 mA, 100 mA and 300 mA test options are available on DC testing.
26
symbol is displayed.