Motorola GM950E Service Manual page 48

Transmit Signalling Circuits
5.0 Transmit Signalling Circuits
Refer to Figure 4-2 for reference for the following sections. From a hardware point of view, there are
three types of signalling:
1. Sub-audible data (PL / DPL / Connect Tone) that gets summed with transmit voice or signal-
ling,
2. DTMF data for telephone communication in trunked and conventional systems, and
3. Audible signalling including Select 5, MPT-1327, MDC, Single Tones.
All three types are supported by the hardware while the radio software determines which signalling
type is available. Currently only PL/DPL and Single tones are supported in the software.
MICRO
CONTROLLER
U0101
5.1 Sub-audible Data (PL/DPL)
Sub-audible data implies signalling whose frequency is below 300Hz. Although it is referred to as
Ósub-audible data,Ó the actual frequency spectrum of these waveforms may be as high as 250 Hz,
which is audible to the human ear. However, the radio receiver Þlters out any audio below 300Hz, so
these tones are never heard in the actual system.
Only one type of sub-audible data can be generated by U0103 (AFIC) at any one time. The process
is as follows, using the SPI BUS, the µP programs the AFIC to set up the proper low-speed data
deviation and select the PL or DPL Þlters. The µP then generates a square wave which strobes the
AFIC PL / DPL encode input PL CLOCK STROBE U0103-32 at twelve times the desired data rate.
For example, for a PL frequency of 103Hz, the frequency of the square wave would be 1236Hz.
This drives a tone generator inside U0103 which generates a staircase approximation to a PL sine
wave or DPL data pattern. This internal waveform is then low-pass Þltered and summed with voice
or data. The resulting summed waveform then appears on U0103-19,20 (MOD IN), where it is sent
to the RF board as previously described for transmit audio.
4-10
62
54
13 AUX TX
IN
58
39
GCB1
PL
GEPD_5432
57
32 CLOCK
STROBE
Figure 4-2 Transmit Signalling Paths
SPLATTER
FILTER
ASFIC U0201
LS
PL
SUMMER
ENCODER
ATTENUATOR
TO RF
19, 20
SECTION
MOD IN
(SYNTHESIZER)
GEPD 5432
Theory of Operation