Table of Contents
Advertisement
General Information
ICE FLOW RESTRICTOR
An optional ice flow restrictor decreases the amount of
ice allowed to enter the ice chute by blocking a small
area at the entrance of the dispenser chute. This in turn
restricts the flow of ice that is dispensed into your cup.
Please refer to the instructions included in kit #5013822
for more information on how to install.
Ice Flow Restrictor
NOTE: For full information about icemaker installation,
including plumbing lines connections and electrical
requirements, see the icemaker installation manual.
LEGS
Legs are optional equipment with most MBE dispensers.
Standard legs are four-inch (10.2 cm) tall stainless steel
legs. It is recommended if an icemaker is installed on top
of the dispenser, legs must not be installed. When
installing legs on a dispenser, leg braces must be used.
These are metal braces fitting side to side under the
dispenser that reinforce the leg attachment area.
1-2
Serial Number Location
This number is required when requesting information
from your local distributor. The serial number is listed on
the SERIAL NUMBER DECAL affixed to the dispenser.
Label
Serial Number Location
Warranty Information
Consult your local MBE Distributor for terms and
conditions of your warranty. Your warranty specifically
excludes all beverage valve brixing, general
adjustments, cleaning, accessories and related
servicing.
Your warranty card must be returned to MBE to activate
the warranty on this equipment. If a warranty card is not
returned, the warranty period can begin when the
equipment leaves the MBE factory.
No equipment may be returned to MBE without a written
Return Materials Authorization (RMA). Equipment
returned without an RMA will be refused at MBE's dock
and returned to the sender at the sender's expense.
Please contact your local MBE distributor for return
procedures.
Section 1
Part Number 020002115 10/11
Advertisement
Table of Contents
