Table of Contents
Advertisement
Maintenance
MONTHLY CLEANING
Unplug unit before servicing or cleaning ice bin.
Ice bin contains parts that can move at any time and
will cause injury if hands are in the way.
When using cleaning fluids or chemicals, rubber
gloves and eye protection must be worn.
Clean and sanitize the ice bin:
1. Unplug unit and remove all ice from the ice bin.
2. Mix a solution of mild detergent to clean the
dispenser bin and components.
3. Wash the ice bin using a sponge and the mild
detergent solution.
4. Using the mild detergent solution and a soft bristle
brush or clean cloth, clean the following dispenser
parts:
•
Entire bin
•
Paddle wheel
•
Paddle wheel area
•
Agitator
•
Paddle wheel pin
•
Ice Chute
•
Rear bushing
•
Motor shaft
•
Strip lids (where applicable)
4-2
! Caution
Warning
!
5. Rinse all the parts in clean, running water.
6. Prepare 2 gallons of sanitizing solution by mixing
1/2 ounce of household bleach (that contains 5.25%
sodium hypochlorite) with 2 gallons of 120°F water.
The mixture should not exceed 100 PPM of chlorine.
Or mix a solution of any approved sanitizer,
following the directions for mixing and applying the
sanitizer.
7. Sanitize the ice bin and cold plate with the sanitizing
solution for at least 10 seconds.
8. Allow to air dry. Do not rinse.
Re-assembling the dispenser parts:
9. Re-assemble parts in the following order:
•
Bin liner
•
Paddle wheel
•
Agitator
•
Paddle wheel pin
•
Ice chute
•
Merchandiser
10. Hand tighten all knurled fasteners.
11. Pour in fresh, sanitary ice and replace the plastic lid
on the top of the dispenser.
12. Plug in the unit's electrical cord.
13. Check for proper ice dispensing.
Section 4
Part Number 020002115 10/11
Advertisement
Table of Contents
