Roland VersaCamm SP-540i User Manual page 101

2.
Execute the [ADJUST BI-DIR] menu item.

Load the media.
 P. 32, "Loading Media," p. 82, "How to Load Sheet Media"

Perform bidirectional adjustment.
 P. 73, "Correcting for Misalignment in Bidirectional Printing," p. 74, "Correcting for Misalignment in Bidirectional Printing More
Precisely"
3.
Print a test pattern and cut it.

MENU
CUTTING MENU

CUTTING MENU
CROP - CUT ADJ.

CROP - CUT ADJ.
TEST PRINT
Cutting position and printing
position are misaligned.
When adjustment is needed, go on to the steps below.
4.
Print and cut a test pattern for adjustment.
CROP - CUT ADJ.
TEST PRINT 2
5.
From the test pattern, read the correction value at the location.
Test pattern
Correction-value scale
Check the value on
the [FEED] side.
4-9 Performing Printing and Cutting Separately
Press .
Press .
Press .
Press .
Press .
Press .
Cutting
position
Printing
position
Cutting position and printing
position are aligned.
Press .
Press to execute.
Check the value on
the [SCAN] side.
Scan direction
Cutting line
Cutting
position
Printing
position
Cutting line
The point where the cutting line
intersects the correction-value scale is
the correction value. In this figure, the
value is "-0.3." Use the same method
to read the value on the [FEED] side.
99