Advertisement
2.1.3 Removing the front panel assembly
(See Fig.6~9)
• Prior to performing the following procedure, remove the metal
cover and the CD changer mechanism assembly.
(1) Disconnect the card wires from connector CN44 and
CN870, disconnect the flat wire from connector CN922 on
the main board on the right side of the body. Remove the
screw D attaching the wire from extending from the under-
side of the front panel assembly.
(2) Disconnect the wire from connector CN701 on the bridge
board.
(3) Cut the band.
(4) Disconnect the wires from connector CN231 and CN232
on the primary board on the left side of the body.
(5) Remove the plastic rivet attaching the inner bar in the cen-
ter of the front panel assembly.
REFERENCE:
Keep the plastic rivet for reuse.
(6) Remove the three screws E attaching the front panel as-
sembly at the bottom of the body.
(7) Disconnect the ground wire extending from the phone
board from bottom chassis.
(8) Release the two joints a on the lower left and right sides of
the front panel assembly using a screwdriver, and remove
the front panel assembly toward the front.
REFERENCE:
Front panel need to be tilt little bit as release from bottom
chassis.
Front panel assembly
Joint a
Main board
CN870
Bridge board
CN701
CN44
CN922
D
Fig.6
Bottom chassis
Fig.7
Plastic rivet
Inner bar
Bridge board
CN701
Fig.8
E
Fig.9
Joint a
Ground wire
Front panel assembly
Primary board
CN231,CN232
Band
(No.22041)1-7
Advertisement
