JVC HX-Z9V Service Manual page 25

2.3.12 Removing the CD mechanism board
(See Fig.26)
(1) On the back of the CD mechanism assembly, unsolder the
four soldering c attaching the CD mechanism board, the
spindle motor and the feed motor.
(2) Removing the screw A.
2.3.13 Removing the Spindle motor/Feed motor
(See Fig.27)
• Prior to performing the following procedure,remove the CD
mechanism board.
(1) Form the top side of the CD mechanism assembly, remove
the two screws B and two screws C attaching the spindle
motor and the feed motor respsctively.
Soldering c Feed motor
Fig.26
B
Spindle motor
Feed motor
Fig.27
Soldering c
Spindle motor
CD mechanism board
A
C
(No.22041)1-25