Advertisement
2.4.2 Removing the head amplifier & mechanism control board
(See Fig.4)
(1) Turn over the cassette mechanism assembly and remove
the three screws A attaching the head amplifier & mecha-
nism control board.
(2) Disconnect the flexible wire from connector CN31 on the
head amplifier & mechanism control board.
(3) Disconnect connector CN32 of the head amplifier & mech-
anism control board from connector CN1 on the reel pulse
board.REFERENCE: If necessary, unsolder the 4-pin wire
soldered to the main motor.
2.4.3 Removing the main motor
(See Fig.4~7)
(1) Remove the two screws B .
(2) Half raise the motor and remove the capstan belt from the
motor pulley.
ATTENTION:
Be careful to keep the capstan belt from grease. When reas-
sembling, refer to Fig.6 and 7 for attaching the capstan belt.
Head amplifier & mecha control board
A A
CN31
A
Flexible wire
CN32
4pin wire
B
Main motor assembly
Fig.4
Main motor assembly
Capstan belt
Fig.5
Capstan belt
Fig.6
Main motor assembly
Fly wheel
Capstan belt
Fig.7
Main motor assembly
Motor pulley
Motor pulley
(No.22041)1-27
Advertisement
