Advertisement
Why RAB Sensors are Best for You
Smaller is better! Mini Sensor uses state-of-the-art surface mount
technology (SMT), just like cellular phones and beepers. SMT gives you
more reliability, greater RF immunity, and a compact sensor that can fit
neatly where others cannot.
Wider is better! The wide 180º view detects movement along the
entire side of a building with only one compact sensor. It will detect
people as they exit or enter. It takes several conventional sensors to
get the same coverage.
Molded is better! No leaky gaskets or bug hotels with Mini Sensor. The
hard lens is molded as part of the case. It's vandalproof, rainproof,
bugproof and absolutely sealed.
Sensor
180º
3
Cautions
• All wiring MUST comply with local
electrical codes and should be
installed by a qualified electrician.
• Read entire Installation Manual
before proceeding.
TURN OFF POWER BY REMOVING
POWER FUSE OR TURNING
OFF CIRCUIT BREAKER
BEFORE INSTALLATION.
• Total lighting load must not exceed:
Relay On/Off Model: 5 amps,
500 watts incandescent quartz or
250 watt fluorescent at 120 volts.
To switch more wattage, an electri-
cian can install an additional relay.
Hi/Lo Model: 180 watts quartz
and incandescent only.
• Line Carrier Remote Control
Systems such as X-10, Leviton or
Radio Shack are incompatible with
sensors and cause false activations.
• Do not install on circuits feeding
motor loads such as kitchen appli-
ances, HVAC equipment, washer/
dryer or garage door openers.
• Sensor functions best when
movement is across its detection
pattern, not towards the sensor.
• Mount 6'-10' high for optimum
range and direction.
4
Advertisement
