Molded is better! Withstands up to 3000 Volts 5 seconds to 15 minutes No leaky gaskets or bug hotels with Mini Sensor. The hard lens is molded as part of the Manual Override: case. It’s vandalproof, rainproof, bugproof and absolutely sealed.
Page 3
Caution Assembly and Wiring • Basic Wiring Diagram All wiring MUST comply with local Screw the threaded arm of the sensor electrical codes and should be installed into the center hold of the mounting by qualified electrician. plate. Sensors can be wall or ceiling mounted.
Wiring Diagrams How Does RAB’s Mini Sensor Work? To override sensor with a manual switch How are the Time, Sensitivity and The Mini Sensor infrared sensor “sees” Photocell adjusted? small temperature changes caused by the motion of people or cars within...
Page 5
• For the first 30 seconds, the lights will between 5-8 minutes. This period • • Mini Sensor may be wall or ceiling Detection extends out a maximum of be turned on. During this time, test starts after the movement in the mounted.
Page 6
1/16”. This small screws. adjustment may move the zones to 3. Make sure that Mini Sensor is not allow earlier detection. mounted on an unstable object such as a tree or a pole that will move in the wind.
Page 7
Technical Tips: Lights Turn Off Technical Tips: Lights Do Not Turn On Too Quickly Lights Turn On and Off Incorrectly 1. Check that lamps and fixtures work. 1. Check if sensor is being “tricked” by 1. Make sure the sensor is installed 5.Make sure lights are not visible from or Compare wiring to the Wiring reflected light.
Page 8
Product Warranties Reasons 1. Lights may turn on occasionally during The RAB Mini Sensor will be free from defects The following warranties apply to RAB Lighting, Inc. (“RAB”) York and buyer agrees that such courts are a convenient products that meet all of the following conditions: (a) the forum for adjudication.