RAB Lighting VX Series Installation Instructions

RAB Lighting VX Series Installation Instructions

Cfl

Advertisement

VX/ VXBR CFL INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture.

MOUNTING

Fixture should be located on wall or ceiling and not be
recessed. Use the Housing Template to match the recessed
or surface mount Junction Box (not supplied) or use the
Housing to make electrical connections. Fixture cannot be
mounted upside down in wet locations. For more secure
installation, lag bolt ballast box to mounting surface.
1. Loosen Housing Screws from Front of Housing.
2. Prepare Back of Housing for use by knocking out the
appropriate mounting holes.
3. Seal all gaps between ceiling and fixture with
weatherproof silicone sealant. (Be sure to use the Gasket
supplied.)
4. Fixture may be wired through back conduit entrance or
either side conduit entrance for surface mounting.
5. Connect wires as shown in wiring section. The Back of
Housing has a Tether Cable and the Front of Housing
has a Loop for hanging the fixture during wiring.
6. Reattach the Front & Back Housing. Be sure the original
Gasket seals properly. Tighten Housing Screws.
7. Install the lamp, globe and guard.
8. Seal all holes, plugs and conduit entrances with
weatherproof silicone sealant.
Back of Housing
Loop for
Tether
Housing
Screws
Housing Template
Junction
Back of Housing
Box on Wall
Gasket
Front of Housing
Tether
Cable

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VX Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for RAB Lighting VX Series

  • Page 1 VX/ VXBR CFL INSTALLATION INSTRUCTIONS Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE.
  • Page 2: Lamp Installation

    VX/ VXBR CFL INSTALLATION INSTRUCTIONS Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com...

This manual is also suitable for:

Vxbr series

Table of Contents