Kohler CFI230G Fitting Instructions Manual page 13

Fit the Suppression Ferrite close to
the Water Delivery connector
Note:
The Suppression Ferrite is packed with the
Digital Mixer
Place the cable in the
suppression ferrite. Wrap
the cable around the cover
and through the ferrite
again and then close the
cover until it snaps shut
Support the weight of the column. Connect
the water pipe to the connector from
at the top of the column.
Plug the electrical cable into the connector
from the Water Delivery System at the top
of the column.
Caution
16
CFI230G
Slider Rail Water Delivery Only
(See Step 42 for the Fixed Head Water Delivery)
Carefully lift the Water
Delivery System column
and place the bottom
into the jamb assembly
Be very careful not
to scratch or damage
the tray
STEP
38
Push top of column
into jamb assembly
until it locks in place
PROCEED TO
STEP
STEP 47
40
Fit the fixed roller to the tray on the same side as
lintel wall fixing.
Note: The seal 'A' on the glass panel will need
to be pulled away, to allow the roller to be fitted,
and re-fitted afterwards.
Push the roller onto the slot in the tray until it
locks in place ensuring the plastic glass
guide is retained inside the roller body
A
STEP
39
Push the door stop vinyl into the track and
against the fixed roller
STEP
41
Fit the blanking cover on the other side
of the tray.
Note: The seal 'A' on the glass panel will need
to be pulled away, to allow the cover to be fitted,
and re-fitted afterwards.
STEP
26
Carefully lift door into the enclosure
Important: Requires a minimum of 2 people
Caution
STEP
28
STEP
27
STEP
29
13
CFI230G