The Appliance Stops Following An Overload; The Motor Runs But The Knives Do Not Rotate - Santos 33 User And Maintenance Manual

SANTOS : Instruction and maintenance manual
The motor is protected by a built-in cut-out system. If it overheats the motor stops.
• Turn the On Off switch (9) to position 0, take out the plug.
• Wait for the motor to cool down (20 to 45 minutes), then turn the On / Off switch (9)
on (position 1).
If the problem persists, switch off the power supply to the machine (unplug the power
supply cord (10)) and call in the maintenance service or contact a SANTOS-approved
dealer.

The appliance stops following an overload:

If the motor jams (foreign body, matter or food too hard jamming the knives), it may heat
up very quickly and cut out due to overheating.
• Switch off the appliance (unplug the power supply cord (10))
• Switch the on / off switch (9) to position 0.
• Remove the bowl assembly (1) from the motor unit (2) and place it on a work top.
• Remove the lid (3) from the bowl and with a long, thin object, shift the hard bits
jamming the knives.
• Put back the bowl assembly (1) onto the motor unit and switch back on.
• If the knives get jammed again, empty the bowl and cut the food up into small pieces.
If the problem persists, switch off the power supply to the machine (unplug the power
supply cord (10)) and call in the maintenance service or contact a SANTOS-approved
dealer.

The motor runs but the knives do not rotate:

• Check: the seating of
the bowl assembly (1)
on the motor unit (2),
(Fig. I).
• Check: the condition of
the coupling system (11
and 12).
• Check: the bowl seal (5)
is positioned correctly
(see "assembly
preparation" part).
.
98133 US 5.0 - 01 2013
and
WRONG POSITION
14 / 19
Fig I
RIGHT POSITION
www.santos.fr