SANTOS : Instruction and maintenance manual CONTENTS “CE” COMPLIANCE DECLARATION ..................3 SAFETY INSTRUCTIONS....................4 INSTALLATION AND HANDLING..................4 IMPORTANT RESTRICTIONS: ..................4 ELECTRICAL CONNECTION: ..................4 USING FOR THE 1st TIME....................5 RECYCLING THE PRODUCT AT THE END OF ITS SERVICE LIFE ......5 DESCRIPTION OF THE APPLIANCE .................6 USING THE APPLIANCE ....................6...
SANTOS : Instruction and maintenance manual “CE” COMPLIANCE DECLARATION THE MANUFACTURER: SANTOS - 140-150, Av. Roger SALENGRO 69120 VAULX-EN-VELIN (LYON) FRANCE declares that the appliance intended for the professional market described below: Description: PLANETARY MIXER Type number: complies with: the statutory provisions defined in appendix 1 of the European "machines" directive n°2006/42/CE and the national legislation transposing it...
6. Unplug the appliance before any intervention on it: cleaning, general care, maintenance. 7. Use of spare parts other than certified original SANTOS parts is prohibited ELECTRICAL CONNECTION: The electric power supply for the appliance is available in 2 single-phase voltages...
For further information you can contact your dealer or SANTOS. For the disposal or recycling of the appliance components, please refer to a specialist company or contact SANTOS.
SANTOS : Instruction and maintenance manual DESCRIPTION OF THE APPLIANCE The beater-mixer can be used to beat, mix and whisk preparations made by professionals in restaurants, pizza houses, snack bars, catering outlets, sandwich bars, special theme restaurants, etc. The appliance consists of an aluminium body and stainless steel plating.
Page 7
SANTOS : Instruction and maintenance manual (whisking), those in the middle for medium speeds (work with the paddle), and the furthermost notches for slow speeds (work with the hook). 7. The grid must be down and the bowl in the raised position before starting the appliance by putting the on/off switch (13) to position 1;...
SANTOS : Instruction and maintenance manual CHANGING THE TOOL All tool changes must be carried out with the appliance halted and the bowl support in the lowered position. FITTNG: 1. Place the tool on the rotating shaft (16) 2. Push the tool upwards, 3.
SANTOS : Instruction and maintenance manual SAFETY / MAINTENANCE SAFETY DEVICES If the problem persists, switch off the power supply to the machine (unplug the cord from the mains socket (8)) and call in the maintenance service or contact a SANTOS approved dealer.
(19). The appearance of an electric arc shows that the capacitor has discharged. Spare parts: IMPORTANT: Use of spare parts other than certified original SANTOS parts is prohibited This machine requires no specific maintenance. The bearings are lubricated for life.
Page 11
SANTOS : Instruction and maintenance manual 3. After installing the belt (20), turn the driven pulley (21) by hand and gradually pull the speed control lever (10) until it reaches the high speed position. 4. Once in this position, check the distance for the top of the belt at the outer diameter of the drive pulley (21) (minimum distance 39 mm, maximum 40 mm): see the sketch.
SANTOS : Instruction and maintenance manual FAULT FINDING Identifying the cause of appliance stoppage with precision. If the problem persists, switch off the power supply to the appliance (unplug the cable from the mains socket) and call in the maintenance service or contact a SANTOS approved dealer.
SANTOS : Instruction and maintenance manual Electrical diagrams 110-120V 50/60Hz wiring diagram Blue Black Yellow White White Brown White Black Starter relay On / Off U< Brown Blue Switch (bowl) Switch (Grid) Stop Brown Brown Brown 15 and 16 Green / yellow 98127 EN 2.2 - 12 2010...
SANTOS : Instruction and maintenance manual 380V / 220V 50Hz three-phase wiring diagram Black Brown Noir Black Yellow Switch (bowl) Orange White Brown 220V three- Switch (Grid) phase MOTOR connection White White White White White RELAY White Blue Brown Blue...
SANTOS : Instruction and maintenance manual 220-240V 50/60Hz wiring diagram Black Brown White White White Black Starter relay On / Off U< Brown Blue Switch (bowl) Switch (grid) Stop Brown Brown Brown 15 and 16 Green / yellow 98127 EN 2.2 - 12 2010 16 / 19 www.santos.fr...
Page 17
SANTOS : Instruction and maintenance manual item F Locking lever Bowl Bowl support Bowl centering device “Hook” tool “Paddle” tool “Whisk” tool Mains power cable Grid Speed control lever Rack Column On-Off switch "Mushroom-head" switch Motor Tool shaft Cover fixing screw...
In case of revelation of an imperfection during the warranty period, the Distributor has to, unless a different written agreement of SANTOS, indicate to his customer to stop any use of the defective product. Such a use would release SANTOS of any responsibility.
Need help?
Do you have a question about the 27 and is the answer not in the manual?
Questions and answers