Canon LaserBase MF5600 Service Manual page 110

Chapter 3
2) Remove the front screw [1] and then remove the
claw [2].
3) Slightly lift up the left side of the unit and remove
the cover as if you were opening the bottom side of
the left cover [3].
[2]
[3]
[1]
F-3-233
3.2.3.6 Removing the NCU
Board
1) Remove the two connectors [1] and the flat cable
[2].
2) Remove the two screws [3] and remove the NCU
board [4].
[3]
[4]
[2]
F-3-234
3-54
0006-3647
[1]
3.2.3.7 Removing the NCU
Case
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
[2]
F-3-235
3.2.3.8 Removing the Scanner
Unit
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
[2] [1]
F-3-236
0006-3641
[1]
0006-3643
[3]