Replacement Procedures; Replacing The Separation Module And Tires - Kodak Scan Station 520 EX Administrator's Manual

Replacement
procedures
Replacing the separation
module and tires
7-8
Kodak Scan Stations use replaceable tires that can feed a wide range
of document types, sizes and thicknesses. Tire life and performance
will vary based on the customer's document set, the frequency of
cleaning the paper path and tires, and following the recommended
schedule for changing tires. Nominal tire life is approximately 125,000
pages. Usage figures are not guaranteed. Customer-operating
environments, document type, the condition of documents being
scanned, and not following the recommended cleaning and
replacement procedures, can cause the life of the consumables to vary.
You should change the tires if you notice an increase in multiple feeds,
stoppages, or a decrease in feeder performance that is not resolved by
following the cleaning procedures.
NOTES:
• Before beginning replacement procedures, turn off the Scan Station
and disconnect the electrical power.
• Certain paper types (such as carbonless paper or newsprint), failure
to clean regularly, and/or use of non-recommended cleaning solvents
can shorten roller life.
1. Push the separation module up to snap out and lift it out of position.
• If you are replacing the separation module, insert the new
separation module by aligning the tabs with the slots and
snapping it into position.
• If you are replacing the tires, continue with Step 2.
A-61628 December 2011