Vacuuming The Scan Station; Cleaning The Imaging Area - Kodak Scan Station 520 EX Administrator's Manual

Vacuuming the Scan
Station

Cleaning the imaging area

7-6
6. Reinstall the feed module by aligning the pins and pushing it toward
the left to fit it into position. Be sure the gears are aligned and it
snaps into place. Roll the feed module back into place.
7. Reinstall the feed module cover by aligning the tabs with the slots
and pushing it back into position until it snaps into place.
Before cleaning the imaging area, it is suggested that you vacuum the
inside of the Scan Station to remove any dust and debris.
1. Wipe the upper and lower imaging area using a Staticide wipe. Be
careful not to scratch the imaging area when cleaning.
IMPORTANT: Staticide wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the MSDS for more information.
2. Wipe the upper and lower imaging area again using the reusable
optics cleaner pad to remove any streaks.
3. When finished, close the Scan Station cover with both hands.
A-61628 December 2011