Rear Ir Input Menu - PROCEED Audio Video Preamplifier Manual

Warning!

rear ir input menu

68
as a switch by placing it in series with an external power source
control trigger 1
such as a "wall wart" power supply .
The default settings from the factory are as follows:
• trigger 1 = 12V pulse based on standby/operate toggle
• trigger 2 = 12V level when not in standby (0V when in standby)
The three switches that determine what combination of
uses are located inside your AVP and must be set by a qualified installer.
There are no user serviceable parts inside the AVP!
If you need one of the internal settings changed to support
your installation, please contact your dealer.
The infrared remote input jack on the rear panel of the AVP may be pro-
grammed to respond to either
of the IR receiver in the AVP's
IR repeater, to affect only the
Remote Turn-on section of your AVP manual for more information.)
The factory default setting is
commands from reaching the AVP (as when behind closed doors, for example),
and if you are using an IR repeater to pass IR commands to the system, you may
wish to set the IR input on the rear panel to
want to "hard-wire" the AVP to your IR repeater. To make this software change,
follow these steps:
1 ENTER THE CUSTOM MENU
This menu is accessed from the
, and pressing
custom
2 SELECT REAR IR INPUT
volume ±
Using the
enter.
3 TOGGLE THE MENU ITEM FROM REMOTE TO LOCAL
volume ±
Press either of the
local . Press enter to save the change.
commands (e.g., duplicating the functionality
local
main display ) or remote
signal path). (Refer to the Remote IR and
remote
remote . If your installation of the AVP prevents IR
, in which case you would also
local
main menu by moving the cursor to
to select the menu item.
enter
buttons, move the cursor to
keys to change the default setting of
, or your AVP
5V 12V relay
commands (e.g., from an
and press
rear IR input
to
remote