A Quick Start For Dvd - PROCEED Audio Video Preamplifier Manual

14

A Quick Start For DVD

We understand: you' r e in a rush to hear Dolby Digital on your new system. Re-
member: What follows is not a replacement for a complete setup of the
system. We will assume here that you have already done the CD setup on the
previous page. To get a DVD player playing:
1 MAKE THE PHYSICAL CONNECTIONS
Noting which connectors you use, connect a digital output of your DVD to
any matching digital input on the AVP , and a video output of your DVD to a
corresponding video input on the AVP . Turn everything on.
2 PRESS AND HOLD THE DISC BUTTON ON THE AVP
This shortcut of pressing and holding an input button will take you directly
to the Define Button menu for that button,
3 TELL THE SYSTEM WHICH CONNECTORS YOU USED FOR YOUR DVD
PLAYER IN STEP 1
volume ±
Using the
down to the line that defines your video connection and press
on the front panel). Make sure the AVP knows where you plugged in
mute
your laserdisc player's video output. Change the
rect video input, and press
Similarly, set up your audio connection: move the arrow cursor down
volume ±
( ) to the
audio connectors
that reads 1: digital 2
line, press and with the cursor changed to an arrow within a diamond
enter
→
volume ±
( ), the
you used when hooking up the system.
4 PRESS MENU A FEW TIMES TO EXIT THE MENU SYSTEM, AND ENJOY
Make sure the volume is on at a low level before you fire up your DVD
player; press the
disc
comfortable level. Important: you should properly calibrate the system so
all speakers are playing at the proper volumes before you listen critically to
multichannel audio. Performing this calibration only takes only a few more
minutes, but you should read up on it first. Please review the chapter on
The Setup Menu for more information, pp. 42-58.
disc
buttons (or the
volume knob
to save any changes you need to make.
enter
line and press
, and press enter again. Move down to the
buttons will allow you to select whatever digital input
button once, and raise the volume to a moderate/
in this case .
), move the arrow cursor
enter (or
setting to the cor-
video:
; move to the line
enter
conn ector