A Quick Start For Cd - PROCEED Audio Video Preamplifier Manual

A Quick Start For CD

There is a reasonable chance that either your CD transport or your DVD player
may have a different set of output connectors than what we have assumed it
might have in the "quickest start" section. In that case, setting up the AVP to take
advantage of your particular equipment is still quite simple, though it will require
a couple extra steps.
1 MAKE THE PHYSICAL CONNECTIONS; TURN EVERYTHING ON
Connect the outputs of the AVP to your power amplifier(s), as indicated
(front, rear, center, sub); connect a CD transport to any matching digital in-
put connector on the AVP , noting which connector you use; ensure that the
main video output of the AVP is connected to your television (so you can
see the on screen menus). Once this is done, turn on all the components
involved (CD transport, AVP , television, amplifiers). Turn the amps on last
(always a good habit with any audio system).
2 PRESS AND HOLD THE CD BUTTON ON THE FRONT OF THE AVP
This shortcut of pressing and holding an input button will take you directly
to the
define button
3 TELL THE AVP WHICH CONNECTOR YOU USED FOR YOUR CD
TRANSPORT IN STEP 1
We have no way of knowing what sort of digital interface your particular
CD transport might use (
be able to use your main CD transport with the button labeled
step allows you to use whatever connector you need to use in conjunction
with the button you' d like to use. Using the
(or the volume knob), move the arrow cursor down to the line that reads
" " and press
audio connectors
to move to 1:
volume –
the arrow cursor down to the line that defines which connector is being
used, and press enter
within a diamond (
knob will allow you to select whatever digital input connector you used in
Step 1. When done, press
4 PRESS MENU THREE TIMES TO EXIT THE MENU SYSTEM, AND ENJOY
Make sure the volume is on at a low level before you fire up your CD
player, press the cd
cording to the factory defaults (which you can easily change),
to come on in
2-channel/surround off.
system so all speakers are playing at the proper volumes before you listen
critically to multichannel audio. Performing this calibration only takes only a
few more minutes, but you should read up on it a bit first. Y ou can enjoy
the AVP in regular stereo until then.
menu for that button.
/ ? ? ? -
AES EBU RCA BNC EIA
volume ±
(or
enter mute
and press
Digital 1 enter
( mute ) again. With the cursor changed to an arrow
→
) instead of an arrow, the
( ) again to save your change.
enter mute
button, and raise the volume to a comfortable level. Ac-
Y ou should properly calibrate the
?), but logically , you' d like to
J
. This
cd
button on the remote
on the front panel). Press
( ) again. Then move
mute
volume ±
buttons or the
is preset
cd
13