Example: Setting Up A Laserdisc Player; Defining The Video Connection - PROCEED Audio Video Preamplifier Manual

CD-AUDIO INPUT 1
AUDIO: DIGITAL
CONN: DIGITAL 1
example: setting up
a laserdisc player

defining the video connection

2 PRESS ENTER AGAIN TO WORK WITH "AUDIO:" AND CYCLE THROUGH
YOUR OPTIONS WITH THE VOLUME BUTTONS; CHOOSE DIGITAL AND
PRESS ENTER TO SAVE
Once again, this is the factory default setting. Were you setting up a CD
player that had only analog outputs, though, you would want to change this
to and use a set of analog connectors on the AVP instead.
analog
3 MOVE TO "CONN:" WITH THE VOLUME BUTTONS, PRESS ENTER TO WORK
WITH IT, AND CYCLE THROUGH THE LIST OF CONNECTORS UNTIL YOU
SEE THE ONE YOU USED; PRESS ENTER TO SAVE THIS SETTING, AND
MENU TO RETURN TO THE PREVIOUS/HIGHER MENU
As mentioned during the Quick Start for CD, you can connect any source
component to any appropriate connector, and then simply tell the system
what you have done. It is helpful to have written down what components
are connected where during initial hookup, so you don't have to try to peer
around the back of the system with a flashlight later. A form for this pur-
pose is included at the back of this manual. (Use a pencil, in case some-
thing changes in the future.)
As mentioned earlier, a laserdisc player has several more connections that must
be accommodated than does a simple CD transport. We will run through these
additional settings next, without repeating the sections that remain the same.
DEFINE BUTTON VCR2/DISC2
NAME: LD
TYPE: A/V
VIDEO: COMPOSITE 4
MODE: PRO LOGIC + THX
RECORD DEVICE: NO
AUDIO CONNECTORS
(As a reminder, the path to the
main menu/setup/set source buttons/vcr 2/disc 2
by pressing and holding the
The appropriate type: from the
After having changed
type:
tional item immediately below
connector you wish to associate with a particular button.
1 MOVE TO THE "VIDEO:" ITEM IN THE MENU, PRESS THE ENTER BUTTON
The arrow cursor will change to the "change-it" cursor (
2 CYCLE THROUGH THE AVAILABLE INPUTS UNTIL YOU SEE THE ONE YOU
USED WHEN HOOKING UP YOUR LASERDISC PLAYER
The AVP will cycle through the entire list of available video inputs.
VCR2/DISC2 AUDIO CONNECTORS
AUDIO CONNECTORS: 3
1: DIGITAL 3 RF
2: DIGITAL 2
3: ANALOG 2
INPUT OFFSET:
define button vcr 2/disc 2 menu
—but you can get there faster
vcr 2/disc 2 button for several seconds.)
define button vcr 2/disc 2
to and saved the change, you will see an addi-
a/v
. The item establishes which video
type video:
0.0
shown above is
menu this time is a/v .
→
).
49