Custom Menu - PROCEED Audio Video Preamplifier Manual

Control trigger 1&2 on
trol one or both of the remote turn-on trigger outputs on the rear panel of
the Audio Video Preamplifier independently of the system itself. For ex-
ample, should you decide to use one of these trigger outputs to control am-
plifiers in the remote zone rather than the local amplifiers, learning these IR
commands would allow you to turn the remote amplifiers on and off (even
from across the house) without affecting the operational status of the main
home theater.
The
lished during initial setup and using the front three loudspeakers full-range,
without any help from the subwoofer(s). (Specifically, it turns off the cross-
over and the subwoofer output when
ture may be used to compare the performance of the system configured
with and without the subwoofer(s). (Note that pressing
return the system to its calibrated setup configuration, regardless of its cur-
rent status.)

custom menu

Having gotten through the nearly endless teach remote capabilities of the AVP , the
remainder of the custom menu is used to configure and define how you want
the AVP triggers to operate, and to configured the rear panel IR input. When you
enter this menu, you see something like this:
A trigger
changing back and forth from
IR command
be set independently of the other.
The
type
or a
pulse
Internal settings
trical result of these triggers is a nominal
contact
relay
the Audio Video Preamplifier can provide). If this last is the case, you can use
PRESS MUTE TO TEACH
and control trigger 1 & 2 off
feature will toggle between the configuration estab-
sub/crossover
TEACH REMOTE
TRIG 1 SOURCE: STANDBY
TRIG 1 TYPE: PULSE
TRIG 2 SOURCE: STANDBY
TRIG 2 TYPE: LEVEL
REAR IR IN: REMOTE
refers to what the trigger takes it cue from: either the system
source
standby
(learned in the teach remote menu). Each of the two triggers may
refers to whether the output of the trigger is a
(simulating the action of a momentary-closure contact switch).
within the Audio Video Preamplifier determine whether the elec-
(should you require to source more current or a higher voltage than
SPECIAL
CONTROL TRIGGER 1 ON
CONTROL TRIGGER 1 OFF
CONTROL TRIGGER 2 ON
CONTROL TRIGGER 2 OFF
SUB/CROSSOVER
make it possible to con-
sub/crossover off
CUSTOM
to operate, or an independent
level
or , or even the closing of a dry
5V 12V
is selected.) This fea-
will always
recall
(constant) trigger
67