Operating The Dishwasher - Kenmore 630.1395 Use & Care Manual

Canceling a cycle
• Open the door slightly to stop the cycle.
• Wait for a few seconds before opening the door all the
way.
• Press the "CHINA GENTLE" and "QUICK RINSE" button
at the same time.
• Close the door. The dishwasher will drain any remaining
water.
ADDITIONAL FEATURES
Countdown Display
The countdown display indicates the time remaining for a
cycle to complete. The time will change based on water
temperatures and control settings.
Cycle Completion Signal
The cycle completion signal alerts you when a cycle
completes and the dishwasher has washed and dried the
dishes. You can choose to disable the tone or adjust the
volume.
NOTE: To be able to adjust or disable the cycle completion
signal tone, the dishwasher must not be in operation.
To adjust the signal tone:
• Press and hold the "QUICK RINSE" button then press
and hold the ON/OFF button.
• When the "QUICK RINSE" light illuminates and the tone
goes off, release both buttons.
• Now press the "QUICK RINSE" button until you achieve
the desired volume or until there is no tone (to turn off).
• Press the ON/OFF button to save the setting.
Time Delay
This option allows you to delay the start time of your dish-
washer. To activate:
•
Turn the dishwasher on.
•
Select the desired wash cycle.
•
Press and hold the Delay Start button. Release when
the desired delay time is shown in the display window.

OPERATING THE DISHWASHER

Changing a cycle
• Open the door slightly to stop the cycle.
•
• Press the "CHINA GENTLE" and "QUICK RINSE" button
• Select new cycles and options.
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not fully
open the door until water noises have stopped.
14
Before opening door all the way, wait a few seconds
for water to drain to the base of dishwasher tub.
twice to reset.
WARNING