Philips VARI-Lite VL4000 User Manual page 108

❋
VARI LITE - VL4000 S
Rotating Gobo Assembly
(gear side towards front of
luminaire)
CAUTION:
Front of Assembly Shown
(side towards front lens)
Note:
Assembly shown for clarity.
Rotating Gobo
Assembly Orientation
VERY IMPORTANT!
Side shown (to right) is non-reflective side. The non-reflective side
must face the front lens.
Rear of gobo is the REFLECTIVE side and MUST be towards lamp.
VL4000 spot luminaires accept glass gobos only. Use of metal
gobos in these luminaires may damage gobo assembly and will void
the luminaire warranty.
Step 7. After ensuring main gear slot and gobo assembly timing marks are properly aligned (as
described in Step 7, install replacement rotating gobo assembly into gobo position. Note
orientation of rotating gobo assembly as indicated in
Step 8. After rotating gobo assembly is installed, reinstall head cover(s).
90
L U
POT UMINAIRE SER
Do not touch glass with bare fingers.
Handle by gobo carrier only.
Figure A-9: Rotating Gobo Wheel - Gobo Installation
03 Feb ru ary 201 5
' M
S ANUAL
Rotating Gobo Assembly
Retaining Tabs
(Retaining clips need to be
seated in pins but are not
used to aid in removal)
Rotating Gobo
Wheel Assembly
Open Position
(no gobo)
Figure A-9.
02 .9 704 .00 01 D