Repairing A Torn Ribbon - Kodak 8500 User Manual

Repairing a Torn Ribbon

1. Position the ribbon cartridge with the torn ribbon on a clean
place as shown below.
2. Place a piece of office tape on the center of the ribbon.
3. Wind the takeup spool counterclockwise so that the office tape is
not seen and the ribbon is straight.
4. Install the repaired ribbon cartridge in the 8500 printer.
CONTENTS PRINTER DRIVER GUIDE
Office tape
Supply spool
Takeup spool
SEARCH HELP
Introduction
Setting up the 8500
Printer
Operating the 8500
Printer
Troubleshooting
Site Specifications
Accessories and
Supplies