Loading The Ribbon - Kodak 8800 User Manual

Setting Up the Printer

Loading the Ribbon

Label/wrapper
Supply spool
Bar code
1-6
To load the ribbon into the printer:
If you are replacing a ribbon, remove the used ribbon from the printer.
1.
NOTE: Images remain on the ribbon after printing. If you need to maintain
confidentiality, dispose of the used ribbon appropriately.
Insert your fingers into the holes in the plastic on the end of the ribbon.
2.
Remove the plastic cover from the ribbon.
Do not remove the label/wrapper from the ribbon at this
IMPORTANT:
time.
Push the right end of the supply spool into the front spool holder on the
3.
right.
Place the bar code end of the supply spool into the front spool holder on
4.
the left.
Make sure to line up the notches on the supply spool with
IMPORTANT:
the lugs on the spool holder.
4J2007 July 2006