Morso 1600 Instruction Manual page 2

SUPPLEMENT TO INSTALLATION /
OPERATING INSTRUCTIONS
INSTALLATION CLEARANCES AND FLOOR PROTECTOR (HEARTH)
REQUIREMENTS:
REFER TO ATTACHED AS 2918 CONFORMANCE INFORMATION –
DISREGARD ANY CONTRADICTORY INFORMATION IN
INSTRUCTION MANUAL.
N.B. FOR MORSO MODELS 1410,2110,2140 & 1600
SUPPLEMENTARY HEAT SHIELD MUST BE FITTED TO REAR OF
APPLIANCE TO MEET STATED CLEARANCES.
FUEL TYPE:
REFER TO COMPLIANCE LABEL – DISREGARD ANY CONTRADICTORY FUEL TYPE
INFORMATION IN INSTRUCTION MANUAL
WARNING: THE APPLIANCE & FLUE SYSTEM SHALL BE INSTALLED IN ACCORDANCE
WITH AS/NZS 2918 AND THE APPROPRIATE REQUIREMENTS OF THE RELEVANT
BUILDING CODE OR CODES.
WARNING: APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD SHALL
COMPLY WITH THE REQUIREMENTS OF AS/NZS 4013 WHERE REQUIRED BY THE
REGULATORY AUTHORITY, I.E. THE APPLIANCE SHALL BE IDENTIFIABLE BY A
COMPLIANCE PLATE WITH THE MARKING "TESTED TO AS/NZS 4013".
ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN APPROVED IN WRITING
BY THE TESTING AUTHORITY IS CONSIDERED TO BE IN BREACH OF THE APPROVAL
GRANTED FOR COMPLIANCE WITH AS/NZS 4013.
CAUTION: MIXING OF APPLIANCE OR FLUE SYSTEM COMPONENTS FROM DIFFERENT
SOURCES OR MODIFYING THE DIMENSIONAL SPECIFICATION OF COMPONENTS MAY
RESULT IN HAZARDOUS CONDITIONS. WHERE SUCH ACTION IS CONSIDERED, THE
MANUFACTURER SHOULD BE CONSULTED IN THE FIRST INSTANCE.
CAUTION: CRACKED AND BROKEN COMPONENTS, e.g. GLASS PANELS OR CERAMIC
TILES, MAY RENDER THE INSTALLATION UNSAFE.